WELCOME TO SECURAM SUPPORT

TOUCH

SMART HUB

DOOR / WINDOW SENSOR

SMART SAFE LOCK

SECURAM TOUCH

QUICK START GUIDE

SECURAM TOUCH

QUICK START GUIDE

How to:

Add User

 

->  ->   /   

 

  1. Press then 2
  2. Login as Administrator
  3. Press 1 to Add Owner or 0 to Add Visitor
Delete Users

 

->  ->   /   

 

  1. Press ☼ then 3
  2. Login as Administrator
  3. Press 1 to Delete All Owners or 0 to Delete All Visitors
Change Volume

 

->  -> ->

 

  1. Press ☼ then 6
  2. Press 6 to adjust volume  (High / Low / Off)
  3. Press ✔ to set
Change Batteries

The SECURAM Touch uses 2x CR2 batteries to operate. 

  • First remove the battery cover by setting the Visitor switch to show green then push the Visitor switch in to release the battery cover. (as shown below)

 

  • Remove the dead CR2 batteries.
  • Insert new CR2 batteries and place cover back on. 

The SECURAM Touch should say, “Welcome!” if the batteries are installed properly. 

Pair Phone

 

->

 

  1. Press ☼ then 8
  2. Use the SECURAM app to finish the pairing process

 

Lock
  • On the keypad:
    • Press any button except ☼ (when unlocked)
  • In the SECURAM app:
    • Tap lock on Touch device page
Unlock
  • On the keypad:
    • Enter code
    • Scan fingerprint
    • Use key
  • In the SECURAM app:
    • Tap unlock then enter valid code (includes one time code)
Arm System

 

->

 

  1. Press ☼ then 0

(Turns all notifications on in SECURAM app)

Visitor Access
  • Set Visitor Button:
    • Green – allow visitors
    • Red – restrict visitors
Calibrate Lock
  1. Use thumbturn to lock and unlock 3 times
  2. Double beep indicates calibration successful
Reset Lock
  1. Press and hold reset button 8 seconds (until voice prompt is heard)
Pair Lock

Press reset button once